[Gast]

weiß jemand wie ich n levelone treiber unter linus (suse) installier

Ich bin newbie!

auf der diskette steht was von :

The procedure to activate RTL8139 on linux Kernel 2.2.x is as follows:

step 1: compile:
The instruction for compiling the driver is include at the end of
the driver file. (run this instruction at /usr/src/linux)
Or you can use the Makefile included in the driver diskette \Linux.

step 2: insert the driver as module:
insmod rtl8139.o
(run 'lsmod' to see if the module is inserted)

step 3: bind your card to an IP address

/sbin/ifconfig eth0 ${IPADDR} broadcast ${BROADCAST}
netmask ${NETMASK}
(run 'netstat -i' to see if there is a interface 'eth0')

step 4: add your card to IP routing table, then add gateway also your card:
/sbin/route add -net ${NETWORK} netmask ${NETMASK} eth0
(should be able to ping local network now)
gateway:
/sbin/route add default gw ${GATEWAY} netmask 0.0.0.0 metric 1

step 5: start inet deamon.
/usr/sbin/inetd
(you are on the network now)

*make sure that your kernel is built with network, fast_ethernet and module
support. Otherwise, you have to rebuild your kernel.
(1:go to /usr/src/linux directory
2:run 'make menuconfig' or 'make config'
3:mark the options list above.
4:exit and rebuild your kernel.
make dep;make clean;make zImage
the file 'zImage' will be at /usr/src/linux/arch/i386/boot/zImage
5:modify /etc/lilo.conf.(this file specify where kernel image is)
6:run 'lilo' )

You cna run 'netconfig' which will do step 4,5,6 for you.
Then just add a line at the beginning of '/etc/rc.d/init.d/network'.
'insmod /your driver path/rtl8139.o'

then your driver will work every time you boot.

DAS sagt mir aber gar nichts!!

wäre dankbar


max