So weit ich weiß gabs beim K7N2 Delta ILSR einige Leute, die sich beschwerten, dass sich der SATA-Controler (der beim Booten immer etwas Zeit braucht) nicht deaktivieren ließ - ergo auch keine Möglichkeit ihn anzuschalten.
Hier mal mein kompletter BIOS-Baum:
Code:
Standard CMOS Features
Date ...
Time ...
IDE Primary Master DV-516E (Teac DVD)
IDE Primary Slave LITE-ON CD-RW SOHR-5 (Brenner)
IDE Secondary Master None
IDE Secondary Slave None
Drive A 1.44
Drive B None
Video EGA/VGA
Halt On All, But Keyboard
Advanced BIOS Features
Virus Warning D
CPU Internal Cache E
External Cache E
Full Scrfeen LOGO Show D
Quick Boot E
1st Boot Device Floppy
2st Boot Device CDROM
3st Boot Device SCSI
Boot Other Devices E
Swap Floppy D
Seek Floppy D
Boot Up Num-Lock LED On
Gate A20 Option Fast
Typematic Rate Setting D
Security Option Setup
APIC Function E
MPS Table Version 1.4
Boot OS/2 for DRAM>64MB No
Hard Disk S.M.A.R.T. E
Video BIOS Cacheable D
Small Logo(EPA) Show E
Advanced Chipset Features
System Performance Auto
Super Stability Mode E
CPU FSB Clock 166 MHz
FSB Spread Spectrum D
AGP Spread Spectrum D
AGP 8x Support E
System BIOS Cacheable D
Vido RAM Cacheable D
AGP Aperture Size (MB) 64
Integrated Peripherals
IDE Function Setup
OnChip IDE Channel0 E
Pri Master/Slave PIO/UDMA Auto
OnChip IDE Channel1 E
Sec Master/Slave PIO/UDMA Auto
IDE Prefetch Mode E
IDE DMA transfer access E
IDE HDD Block Mode E
Onboard Device
AC97 Audio Auto
MC97 Modem D
OnChip USB V1.1+V2.0
USB Keyboard Support D
OnChip 1394 uto
OnChip LAN(nVidia Auto
MAC Adress (nVidia) D
Onboard SuperIO Device
Onboard FDC Controller E
Onboard Serial Port ...
Onboard IrDA Connector ...
UART Mode Select Normal
Onboard Parallel Port ...
Parallel Port Mode SPP
Init Display First AGP
Power Management Setup
IPCA function E
Sleep State S1(POS)
Power Management User Define
Video Off Method DPMS Support
HDD Power Down D
HDD Down In Suspend D
Power Button Function Power Off
IRQ/Event Activity Detect
PowerOn by PCI card D
USB Resume from S3 D
TRC Resume D
IRQ Activity Monitoring
IRQs Activity Primary
IRQ3-14 E
IRQ8+15 D
Power Status Led Dual
After AC Power Lost Off
PnP/PCI Configurations
PNP OS Installed Yes
Resources Controlled By Auto(ESCD)
PCI/VGA Palette Snoop D
PCI Slot [1..5] IRQ Priority Auto
Onboard SATA IRQ Priority Auto (Einstellung erst durch BIOS-Mod vorhanden, rumspielen brachte nichts)
PC Health Status
CPU Warning Temperature D
Shutdown Temperature D
Warning_Beep E
Frequency/Voltage Control
AGP Clock Control Default
AGP Voltage Adjust 1.5 V
DRAM Voltage Adjust 2.7 V
CPU Ratio by H/W
CPU Vcore Select by H/W
PCI Clock Auto Detect E Entspricht im großen und ganzen den Default-Settings. Ich kann beim besten Willen nichts finden, was ich anders einstellen müsste.
Gruß,
dbenzhuser