Bitteschön...
-klick- Zitat:
Materials
...
1.) Compressor larger than 1/8th Horse Power
2.) Decent sized condenser, try and match it to your compressor, if it was attached to the compressor, you are set.
3.) Capillary Tubing, preferably .7 millimeters
4.) 1/4″ Inner Diameter (I.D.) copper tube
5.) Suction line material, I prefer to use a 3/8″ I.D. copper tubing for my suction lines, but some people use flexible lines, especially flexible stainless steel lines. Just remember it has to be able to hold pressure, preferably 400+ PSI.
6.) An evaporator, it can be anything, so long as it has a surface to place against your processor, and enough surface area inside to let the gas to its work.
7.) 2-3 Schrader valves. These valves are sort of like the valves that are on a pneumatic tire, threaded with a pin valve. These can be found at an HVAC store, usually brazed to a short section of copper pipe.
8.) 2-3 Copper T sections, these sections are used to attach the valves to your system.
9.) 1 filter/dryer, this specialized piece of pipe has a chemical in it that helps remove any moisture and debris
10.) Insulating materials, preferably insulating tape and a short length of Armaflex tubing.
11.) Tools, to be discussed below
...
|
Sollte genau das sein, nachdem Du suchst
Halt uns auf dem Laufenden...
EDIT:
Für evtl. resultierende körperliche Schäden übernehme ich _nicht_ die Haftung !