TweakPC

OCZ Vertex 2 LE E Pro und Agility 2 E neue Firmware 1.23 Download

Montag, 25. Okt. 2010 18:41 - [rj]

OCZ hat eine neue Firmware Version für alle SandForce basierenden SSDs veröffentlicht.

Die Firmware 1.23 ist für OCZ Sandforce SSDs erhältlich: Agility2, Vertex2, Vertex2 Pro, Vertex LE, Vertex2E, Agility2E (Extended). Das Update umfasst einige wichtige Bug fixes, die sich aus dem Changelog ablesen lassen.

Changelog Firmware Version 1.23

Changes/additions since version 1.11
  • Added support for a new capacity point: usable size (raw capacity) 360GB (392GB)
Issues resolved since version 1.11
  • Improved latency behavior. This change does not impact average latency but rather reduces worst case latency
  • Modified IDENTIFY data to indicate that the SANITIZE feature set is supported.
  • Modified temperature read data functionality.
  • Added extra handling of parity errors for improved Soft Error handling
  • Added threshold value for SMART attribute 177 (B1h)
  • Fixed the output of the IDENTIFY DEVICE request to properly indicate if the SMART Feature Set is enabled or disabled.
  • Enabled flash write protection whenever core voltage is turned off.
  • Corrected rare case where SATA link could be dropped during a write operation
  • Improved handling of aborted NCQ commands
  • Fixed corner case hang condition by properly handling a host issued COMRESET during the last DWORD of an NCQ data commend.
  • Modified command handling to give precedence to COMRESET in the case of COMRESET during another SATA error
  • Fixed a panic condition by correctly cleaning up after an internal DMA transfer.
  • Modified SSD Life Left calculations that were sometimes reading low on new drives
  • Fixed an issue that occurred when two commands are waiting for each other to complete.
  • Fixed FW to handle a RAISE RAM parity error without panic

Changes/additions since version 1.21

None.

Issues resolved since version 1.21
  • Mitigated the possibility of data loss to last 10 minutes of real time maximum when drive is used with Windows 7 OS, drive indexing, and very slow rate of writing and drive experiences an unsafe shutdown.
  • Fixed a rare condition in which a drive could hang on a SLEEP command.
Known open issues:
  • SMART command B0 occasionally returns incorrect status.
  • Trim command response times are longer than desired.
  • Can't write-same the whole drive.
  • Resetting SMART PHY event counters has no effect.
  • Whitmore Lake (Intel 3100) Chipset Compatibility.
  • Drive may fail during power cycling test with rapid and short cycles.
  • Compatibility issue during Red Hat 5.4 Linux boot on nVidia MCP55 chipset
  • Sleep followed by non-data commands can sometimes cause the drive to fail to respond to the nondata command.
Weitere Details und den Download der neuen Version findet man im OCZ Support Forum
Verwandte Testberichte, News, Kommentare
ueber TweakPC: Impressum, Datenschutz Copyright 1999-2026 TweakPC, Alle Rechte vorbehalten, all rights reserved. Mit * gekennzeichnete Links sind Affiliates.